Thursday 8 August 2013

First Dragons cast

After a few very hot days (36c in a respirator, goggles and lab coat #melt) casting in the workshop everything went fairly smoothly which was nice. I'm onto the next stage of preping the parts for assembly and base coating.

3 dragons worth (Clients, mine and one to put aside till my son is old enough to enjoy it)


The next step involves removing any mould lines, pour spouts. Working out the pose and adding steel wire pines to aid durability. With so many points of articulation it takes time to set the pose right before gluing.

The feet must be flat to the surface (I tape them to the worktop) for maximum stability and I like the hip to be level so when the torso rotates it doesn't wander off at an odd angle. The wire pins allow me to dry assemble the model and bend them into the right pose. I then glue the joints and the pins help hold the part in the right position.

I base coat the model unassembled so I can make sure every nook has paint on it, then part assemble the model legs, hip, torso, arms for the top coat and detail this still allows me a good amount of access to all sides.



The gauss and UAC5 barrels came so I need to cast make some moulds for them.

As for paint I'm thinking along the lines of one of these unless I'm asked different;




I like bold flat colour schemes over camo. The other dragon will be in heavy guards again and before you say it there was plenty of access to salvaged dragons out side of the Draconis Combine ("So many were produced that the Federated Suns and Lyran Commonwealth employed salvaged Dragons in their own arsenals, while many mercenary commands used captured or purchased models"-sarna). I'm tempted to even add a patched on salvaged limb still in Draconis Combine colours.

1 comment:

  1. as for paint job id deff go with the 1st image you posted. Good strong colours

    ReplyDelete